Removing a screwed-in asbestos insulating board (AIB) panel smaller than 1m2

  1. 1
  2. 2
  3. 3
1 Use the right kit
  • Cover work area with plastic sheets secured with tape to help catch waste
  • Wear a disposable, correctly fitted FFP3 face mask and Type 5 disposable overalls
  • Wear the overalls one size too big and put the legs over the top of footwear
  • Do not re-use disposable overalls and masks
  • Work on any AIB material lasting more than two hours, even if different tradespeople are sharing the work, needs a licensed asbestos contractor. The time limit includes setting up, cleaning and clearing up.

     

    No one tradesperson can work with AIB for more than one hour a week. 

2 Keep dust down
  • Find the screws with a magnet. If they are brass screws the magnet wont work so carefully scrape back the paint instead
  • Put a blob of wall paper paste or shaving foam on the screw head and unscrew the screw through the paste or foam. Put the screws in a plastic sack
  • Carefully take the panel away
  • Wipe the screw holes and the surfaces with a damp cloth then spray both sides of the panel with PVA sealant using a hand held water sprayer
  • Put the used cloth and the panel in the plastic sack without breaking it. If it does not fit, double wrap in plastic sheet and seal with duct tape
  • Paint the remaining screw holes and any surface that was in contact with the panel. Put the paint brush in the plastic sack
  • Get a licensed contractor if the panel is badly damaged, if it is stuck to others with paint or if it is work on soffits
3 Clean up properly
  • Use a damp cloth or Class H vacuum cleaner with a special filter to clean up
  • Do not use a domestic vacuum cleaner or a brush as these will spread asbestos fibres into the air
  • Double bag all waste including masks, overalls, cloths and plastic sheets in plastic sacks, seal with tape and label as asbestos waste
  • Contact the local tips in your area to find one that accepts asbestos waste
Share this how-to guide